Unfold the outer damask fabric pillowtop and sides on top
of your foundation evenly.
Make sure the
HEAD of the bed - which has the holes for the air pump hoses - is at the top. |

Place the top to foot TIETEX SLING foam rails on the
bed cover with the air pump hose holes at the head of the bed. |

Next, spread the second set of longer foam TIETEX side
to side rails across the cover area as shown. |
Lay the two air bladders inside the rails with the
hoses going out the holes at the head of the bed.
Snap the hose connectors into the air pump. Plug in
Pump. Fill up only 80% with air - this allows you to easily add top foam layer
and zip up the pillowtop. |
Shown here is the HEAD of the bed with both mattresses
inside and partially inflated.
Tuck the
air pump under the bed and run the two controllers out to the sides. |
Depending on your model - like the GALAXY Model shown -
place any foam comfort layer over the air bladders.
The UNIVERSE BOXTOP Model has it's own special zippered
area for the foam comfort layer. |
|
Lay the pillowtop padded cover over the
interior foam comfort
layers and carefully zip all around. |
Finish zipping on pillowtop. Make sure mattress is
centered on foundation all around. Place against wall.
Use controllers to finish filling bladders to your
desired firmness on each side while laying on the bed. |
|
See the Installation
Instruction Sheet that comes with your specific model for more details |